
12
Workflow
Introduction
Installing the Wireless Transmitter
Utility
This section describes how to install the Wireless Transmitter
Utility. The Wireless Transmitter Utility is used to copy network
profiles to the camera and is required when configuring the
camera for connection to a computer in image transfer and
camera control modes (either the Wireless Transmitter Utility or
the camera menus can be used for connection to ftp servers in ftp
upload mode; see page 98 for information on using the camera
menus for ftp).
Follow the steps below to install the Wireless Transmitter Utility
under Windows 8, Windows 7, Windows Vista, Windows XP, or Mac
OS X.
❏ System Requirements
Before using the UT-1, WT-5, or the Wireless Transmitter Utility,
confirm that your system meets the following requirements:
Camera
1
Nikon D4, D800, D800E, D7100, and D7000 digital
single-lens reflex cameras. For information on whether
more recent models support the UT-1, see the camera
manual.
Power source
One EN-EL15 rechargeable Li-ion battery or EP-5B
power connector and EH-5b AC adapter (available
separately)
OS
2
Pre-installed versions of Windows 8 (64- and 32-bit
versions), Windows 7 (Service Pack 1, 64- and 32-bit
versions), Windows Vista (Service Pack 2, 64- and 32-bit
versions), Windows XP (Service Pack 3, 32-bit version
only), or Mac OS X version 10.6, 10.7, or 10.8 (Intel CPUs
only).
Comentarios a estos manuales