16
Getting Started
For NFC-compatible Android Devices
1 Prepare for pairing (A9).
• Make sure that the camera is off (the power-on lamp is off).
2 Enable Bluetooth, Wi-Fi, and NFC on the smart device.
• Do not pair from the Bluetooth setting screen of the smart device.
3 Close all apps that use NFC, including the SnapBridge 360/170
app.
• Pairing may fail if apps that use NFC are running.
4 Press and hold down the movie button
on the camera for about 7 seconds to
put it into pairing standby mode.
• When the status lamps flash green at the same
time for a while and then alternately flash green,
the camera enters pairing standby mode.
• If the camera remains in pairing standby mode for
about 4 minutes, it turns off (the power-on lamp
turns off) automatically.
5 Tap the NFC antenna of the smart device
to the Y (N-Mark) on the camera.
• The SnapBridge 360/170 app starts. When Camera
name acquired. Connect? is displayed, select OK.
• If pairing is successful, the screen shown on the right
is displayed.
Connect
KeyMission 360
Comentarios a estos manuales